Excluding PDF versions, files above are HTML and good for viewing.  Please select the PDF link for printable copies.  The PDF files are larger than their counterpart HTML files and will take longer to view due to download times.

MODEL 10S T/S - SPECIFICATIONS

1.0 General Specifications
There will be furnished one (1) only Grind HogTM Model 10S T/S Comminutor as manufactured by G.E.T. Industries, Inc. Rotation shall be in a clockwise direction.

1.1 Design Criteria
The comminutor shall be designed to handle the flows indicated below, within the head loss noted.
a)    hydraulic capacity 1.2 MGD (4500m3/day)
b)    satisfactory operation shall occur under conditions of zero flow
c)    head loss at peak flow shall not exceed 10 inches (250)
d)    design shall be such that the flow enters the size reduction and screening device horizontally and exits vertically downward to
        facilitate the flushing of solids

1.2 Cover Plate
Shall be:
a)    of heavy-duty construction and of high quality cast iron
b)    fitted with 4 position lock down arrangement, and 2 alignment holes for repositioning following service
c)    located on, and positioned by wall mounted supports allowing for ease of removal for inspection and maintenance.

1.3 Rotating Drum Screen
a)    heavy-duty Cast Ductile Iron ASTM 536, grade 60-45-18

1.4 Cutting Elements
a)    replaceable shear bars constructed of high-quality A2 tool-steel shall be attached to the rotating drum. Each shear bar shall be
       machined from solid bar stock, surface ground to establish exact tolerances
b)    the stationary cutting bar, shall be of high-quality 01 tool steel hardened to a minimum of 56 Rockwell C, and shall be reversible,
       allowing for four (4) sets of cutting edges prior to sharpening or replacement
c)    all submerged fasteners shall be of stainless steel

1.5 Motor
Immersible 3 Hp. Motor, 1750 RPM, _____ volt, ____ phase, ____ cycle, suited to periodic submergence. Power cable length 25 ft. (7.6 m).

1.6 Drive Arrangement
a)    the motor shall be close-coupled to a speed reducer drive, a heavy duty planetary gear of the totally enclosed non-vented type
       suitable for total submergence during emergencies
b)    double seals on the output shaft shall ensure flood-proof operation through a reduction ratio of 35:1
c)    the cycloidal reducer shall be capable of withstanding shock loads to 500% of its mechanical rating of 4.27 Hp. and be warranted
       for two (2) years
d)    the drive shall have a minimum full load efficiency of 90% and be pre-lubricated with grease, requiring routing maintenance every
       500 to 1,000 hours

1.7 “Toilet Seat” Channel Mounting System
Shall consist of a box style structure fabricated of 304 stainless steel dimensioned to suit the existing channel and supported from above for ease of installation.